
Home
Technologies
>
Power Oxidizer
>
(Bio-)Refineries
Bio-Ethanol
Ethanol to Ethylene
Ethylene Oxide / Mono Ethylene Glycol
Maleic Anhydride
Gas Processing Solutions
Nitrogen Rejection
NGL Extraction
Helium Recovery
Small- & Mid-scale LNG
Waste Gas Handling
Enclosed Flare/Incineration Unit
Others
Caprolactam
Membrane Separation
OHP - Waste Water Treatment
PuriSoil - Soil Remediation
Services
(Pre-)Feasibility
FEED - Front End Engineering Design
Full Project Execution
Capital & Financing of Projects
Feedstock & Offtake Contracts
About
About Us
Partners
Project Cases
Contact
Power Oxidizer: Waste-Gas-to-Power Station
The Power Oxidizer Powerstation is the only clean power generation solution which runs directly on low pressure, low quality gases which typically cannot be utilized or even flared. By integrating thermal oxidation with proven turbines, the system consumes the widest range of gases from 100% to as low as 1.5% methane – all while producing near-zero NOX emissions.
Economic:
-
Turns waste fuel into a resource: generate power from generally unusable gas sources.
-
Designed to operate on a much wider range of fuels. When configured for low-quality fuels, our systems are designed to operate on gas with concentration as low as 50 Btu/scf (1700 kJ/m3). By comparison, most turbine, engine, and fuel cell systems require fuel quality of significantly higher concentration.
-
Flexible, configurable design; High pressure fuel injection for extremely low emissions, and Low pressure aspiration for use of lowest quality gas.
Environmental:
-
Substantially lower air emissions. Particularly when configured for ultra-low emissions, our Power Oxidizer technology may produce substantially lower emissions of NOx, CO, and VOCs than competitive systems.
-
Designed to achieve Lowest Achievable Emission Rate (LAER) for several major air pollutants (NOx , CO, VOC, PM2.5) in non-attainment areas.
Operational:
-
No chemicals or catalysts used (no urea or ammonia) for emissions control. Unlike other emissions control systems such as selective catalytic reduction, our Power Oxidizer does not use chemicals or catalysts and thus cannot be rendered inactive from catalyst poisoning.
-
Mechanically simple: No actuating parts.
-
Little or no fuel conditioning may be required. When configured for low-quality fuels, our systems are designed to require minimal fuel pre-treatment or conditioning. When configured for ultra-low emissions, we may require some additional fuel conditioning. However, regardless of configuration, our systems are designed to require substantially less fuel pre-treatment than competitive systems.

Contact
Chris van der Zande
+31(0)158 200 700
ccm.vanderzande@gidynamics.nl



Potential Applications of the Power Oxidizer Technology:
Digesters
Coal Mines



Oil & Gas



Manufacturing
Food Processing
Chemicals
Ethanol Plants












Landfills



Power Oxidizer 250 KW (EC250) Powerstation
The Power Oxidizer 250 KW (EC250) Powerstation is the only clean power generation solution which runs directly on low pressure, low quality gases which typically cannot be utilized or even flared. By integrating thermal oxidation with proven turbines, the system consumes the widest range of gases from 100% to as low as 1.5% methane – all while producing near-zero NOX emissions.
Power Oxidizer 333 KW (EC333) Powerstation
The Power Oxidizer 333 KW (EC333) Powerstation is the only power generation solution which runs directly on low pressure, low quality gases which typically cannot be utilized or even flared. By integrating thermal oxidation with proven turbines, the system consumes the widest range of gases from 100% to as low as 1.5% methane—all while producing near-zero NOX emissions.
Power Oxidizer 2 MW (KG2-3GEF/PO) Powerstation
Our next generation product, the Power Oxidizer 2 MW (KG2-3GEF/PO) Powerstation combines our Power Oxidizer technology with a two megawatt gas turbine, developed by Dresser-Rand.


